This shows you the differences between two versions of the page.
io2ss:p0136 [2012/11/30 07:12] 127.0.0.1 external edit |
io2ss:p0136 [2013/01/10 19:48] (current) symtechlabs |
||
---|---|---|---|
Line 3: | Line 3: | ||
* Ensure the iO2SS's signal outputs (green wires) are connected to the appropriate oxygen sensor signal wires leading to the PCM. | * Ensure the iO2SS's signal outputs (green wires) are connected to the appropriate oxygen sensor signal wires leading to the PCM. | ||
* Verify all other wiring and check all solder joints or crimp connectors for loose connections, frayed wires, or corrosion. | * Verify all other wiring and check all solder joints or crimp connectors for loose connections, frayed wires, or corrosion. | ||
- | * If using an iO2SS in manual (signal generation) mode, set DIP switch #3 to ON. | + | * If using an iO2SS in stand-alone mode, adjust the offset potentiometer (OFF) to add voltage offset to the signal. |
- | * If using an iO2SS in automatic (signal augmentation) mode, your oxygen sensor may be damaged. Consider using the iO2SS in manual (signal generation) mode instead. | + | * If using an iO2SS in piggy-back mode, your oxygen sensor may be damaged. Consider using the iO2SS in stand-alone mode instead. |
* Contact [[mailto:support@symtechlabs.com|support@symtechlabs.com]] for further support. | * Contact [[mailto:support@symtechlabs.com|support@symtechlabs.com]] for further support. | ||
\\ | \\ | ||
\\ | \\ | ||
[[start|Return to iO2SS Page]] | [[start|Return to iO2SS Page]] |